It is instinctual for homeowners to contact an HVAC tech when they notice irregularities in their cooling or heating system. These irregularities could be a direct result of a dirty or clogged air filter. We encourage homeowners to check their filters and replace if necessary. It’s also beneficial for homeowners with pets, carpet, or for homes near fields or construction zones to have multiple filters for convenient replacement.
If you can’t see any telltale flow marks, and since the stain is fairly small, look at the underside of the roof for ‘shiners.’ A shiner is a nail that missed the framing member, in this case when the carpenter nailed the roof sheathing to the rafters. Moisture that escapes into the cold attic from the rooms below often condenses on cold nails. Sometimes you can spot this if you climb up into your attic on a cold night. The nails will look white because they’re frosted. When the attic heats up a bit during the day, the frost melts and drips, then the nails frost up at night again and so on. The solution is to simply clip the nail with a side-cutting pliers.
Maintenance is the best way to avoid the most costly home repairs. A few hours on the ladder cleaning out the gutters could save you thousands in foundation repairs. A quick application of sealant on the driveway could buy a few more years before you have to repave the whole thing. We've assembled a list of the 10 most expensive types of home repairs and the best do-it-yourself maintenance tips to avoid breaking the bank.
If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.

Don’t fall for a shingle shakedown! Not all local handyman services have your best interests in mind.  Instead of repairing damaged roofing or siding, they recommend a full replacement, which doesn’t always make financial sense. At Brothers Services, we believe in treating people fairly and making sure you know your options, including affordable ways to extend the life of your roofing and siding.
Don’t let your toilet be a mysterious device in the corner of your bathroom: Toilets actually operate by very simple mechanisms that are easy to understand. The majority of toilet issues—clogs, continuous running water, loud noises, etc.—can be solved with the quick purchase of a replacement part and some tinkering in the tank. Don’t be afraid to open it up and take a look. Also note: These are the things you should never, ever flush down a toilet
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.
Many towns have handymen who work part-time, for friends or family or neighbors, who are skilled in a variety of tasks. Sometimes they advertise in newspapers or online. They vary in quality, professionalism, skill level, and price. Contractors often criticize the work of previous contractors, and this practice is not limited to handymen, but to all trades.[13] Handymen have advertised their services through flyers and mailings; in addition, free websites such as Craigslist and SkillSlate help customers and handymen find each other.[14]

In Need of Residential / Commercial Handyman Services? We Have the Solution For You! Our Services include the following: .•All about electricity, installations, maintenance and repairs •General building work and repairs •General handyman work and repairs •Home maintenance and repairs •Installation of bathroom accessories •Sliding glass door installation •Sliding glass door rollers replacement •Sk ...


You're also less likely to be overcharged if your hire a handyman. Unlike a general contractor or specialist who is more likely to price a job based on the estimated amount of time it will take to complete, you only have to pay a handyman for the hours he works, unless you agree on a flat rate. Handymen can keep their rates low because they don't have to pay additional workers, so they have lower overhead costs than contractors or large companies.
All jobs are guaranteed and down to the customers satisfaction. Our services e.g ELECTRICAL , PLUMBING , CARPENTRY , DOORS ELECTRIC FENCE , GATE MOTORS TILING , WATERPROOFING , PAINTING WELDING HANDYMAN SERVICES E.G: Hanging of pictures, mirrors, white board or pin board, Signage, paintings, wall papers • Hanging of curtains/blinds • Flat pack furniture assembly • Patio ,sliding door instal ...
How to DIY it: A simple cleaning often solves the problem. Start by pulling out the lower dish rack. 
Remove the spray arm and use a thin piece of wire to clean out the holes where water sprays through. Scoop or vacuum out any leftover food 
particles from the filter area, then 
remove the filter screen (above), if possible, and give it a good rinse.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
To illustrate, we divided the handyperson services listed on the table below into three groups, based on their charges for four hours of work. The lowest priced one-third of the companies would charge $239 on average for four hours of work, and they were “recommended” by 96 percent of their customers whom we surveyed (see our ratings tables for handyperson services for ratings). In contrast, the highest priced one-third would charge $445 on average for four hours of work and were “recommended” by only 59 percent of their surveyed customers. Just the opposite of what many consumers would assume.

The term handyman increasingly describes a paid worker, but it also includes non-paid homeowners or do-it-yourselfers. Tasks range from minor to major, from unskilled to highly skilled, and include painting, drywall repair, remodeling, minor plumbing work, minor electrical work, household carpentry, sheetrock, crown moulding, and furniture assembly (see more complete list below.) The term handyman is occasionally applied as an adjective to describe politicians or business leaders who make substantial organizational changes, such as overhauling a business structure or administrative division.[6][7]
How well do the franchise chains perform? One Wall Street Journal reporting team did an informal assessment by hiring handymen all over the United States and asking them to fix a wide range of problems, from a relatively routine leaky faucet to a sticky door.[12] The reporter concluded that "with few licensing requirements and standards for the industry, prices are all over the board."[12] One quote was ten times as large as another.[12] Further, the reporter concluded "A big corporate name is no guarantee of quality or speedy service."[12] One corporate firm took three weeks to fix a stuck door.[12] Service varied from spotty to good, with complaints about unreturned phone calls, service people standing on dining room chairs, leaving holes between wood planking, but liked getting multiple jobs done instead of just one.[12] Customers liked handymen wearing hospital booties (to avoid tracking dirt in houses).[12] The reporter chronicled one experience with repairing a water-damaged ceiling. A franchise firm fixed it for $1,530; a second (non-franchise local handyman) fixed a similar ceiling for $125.[12] The reporter preferred the second worker, despite the fact that he "doesn't have a fancy van -- or carry proof of insurance".[12] Tips for selecting a good handyman include: ask questions, get written estimates on company stationery, make sure handymen guarantee their work, pay with credit cards or checks because this provides an additional record of each transaction, check references and licenses,[20] review feedback about the contractors from Internet sites. To find a competent worker, one can seek referrals from local sources such as a school or church or office park, to see if a staff handyman does projects on the side, as well as ask friends for referrals; a general contractor might have workers who do projects on the side as well.[20] Further, one can try out a new handyman with easy projects such as cleaning gutters to see how well they perform.[20]
If you don’t cover paint chips with touch up paint, they’ll rust and then you’ll have a much bigger problem on your hands. The actual touch up is easy. Just buy touch up paint, fine tip paint applicators and wax and grease remover from any auto parts store. Clean the chip with the wax and grease remover and let it dry. Then dip the applicator in the paint and dab it onto the chip. Don’t add too much or the paint will drip. Let it dry completely and apply wax after 30 days. Get the full guide to using auto touch-up paint here. 
×