Any property repair services are only as good as the people and the tools behind them. That’s why we use only the latest repair and maintenance equipment on every job, no matter how small. Part of our job is to ensure your house is up-to-date and looking its best, so we use only the best resources available in order to make that happen. We offer a variety of handyman services throughout the DC area, including all of the following:
Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.
The table below reports labor charges for one to six hours of work (per worker) for a sample of area handyperson services. (Rates were collected by our telephone shoppers who did not disclose their affiliation with Consumers' Checkbook.) As you can see, there are big differences: For one hour of work, you can pay between $50 and $259; for six hours between $300 and $774. The table also shows companies’ hourly rates.
When you use the Handy app or website, you’ll be connected with local handyman professionals who can take care of this work for you. In addition to freeing up your time for the more important things in life, booking a handyman through the Handy platform will give you the security of knowing that things are being handled by an expert. If the sight of a hammer or screwdriver fills you with anxiety and you’d rather leave things to a professional, the Handy platform is ready to help.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill or a screwdriver, and then reattach everything.
Risk: If your house was built before 1994 and still has the original plumbing fixtures, you’re using 30 to 40 percent more water than a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your savings at epa.gov/watersense/watersense-calculator.