It is not uncommon for power switches and breakers to be accidentally turned off when other appliances are being installed. Homeowners are encouraged to check their circuit breaker to make sure the issue isn’t as simple as needing to turn a switch back on. A circuit breaker is typically located in the garage, although in some homes, the circuit breaker can be found in the basement, hallway or storage room.
Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.
Ask about companies’ hourly labor rates and how many workers are included in the rates (some send two workers to every job). Also ask about minimum charges. Many handyperson services have minimums of two hours or more, and some tack on a half-hour of labor or more for travel time (most home services charge the same fees for travel time regardless of where customers live). If the jobs on your list can be done in an hour, don’t hire a company that charges a three-hour minimum. Because many handyperson services bill labor charges in one-hour increments, have a few optional jobs ready in case you need to fill up a worker’s hour.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
If you can see light creeping beneath exterior doors, air is also escaping. Grab a few packages of self-adhesive rubber foam weatherstripping and go to town, sealing any and all doors that lead outside. Weatherstripping already installed but you’re still suffering from a high gas bill? It might be time to replace the strips installed by the previous owners. Check out this handy tutorial on installing weatherstripping. 

JW were very prompt to reply to our initial quote request in which we described using the master shower caused water to pour down the HVAC return duct and was collecting within the walls and causing water damage on the first floor and in the basement ceiling. We also reached out to see if they could resolve a water issue in a corner of the basement that had become oversaturated during the heavy DC rains this summer causing heavy mold within the insulation and a few rotted studs (in addition to moldy drywall). Josh quickly scheduled a time to come out and take a look at the situation and provided great upfront information regarding what he thought the issue might be (initially believed a ripped rubber liner in the shower), price estimate, and description of the teams they use to work on projects. He estimated 2 workers over 3-4 days for $5,952.00 to $7,936.00 dependent on the severity of the issue and materials required. Once we scheduled the work, Cesar was out on time (a little early every day) from Monday through midday Wednesday. On site Cesar let me know the issue actually seemed to be bad grouting and caulking from the original house flippers. He offered to re-grout the entire shower and re-caulk, then test the shower instead of tearing up the stone tile on the floor. The next day we tested the shower for 10-15 minutes and no leak! Luckily for us the issue was smaller than expected which saved us a lot of hassle and money and I'm glad he opted to try that before blindly tearing up the shower. Beyond the high quality of work in general, a few things stood out in my mind as to how customer-oriented JW is: 1) Cesar constantly checked in if he wanted our opinion on things before moving forward. 2) Within the main leak area, he sprayed anti-fungal solution to prevent residual build up. 3) In the basement leak area, they sprayed base-level drylock to help prevent further issues. 4) We had plans to paint the areas they worked on so we didn't require they to repaint but it was offered to us. When they learned we planned on painting, they primed the area so it was ready for us when we got to painting it. 5) The cleanup crew collected all leftover materials and some extra left by the original flippers. Overall the project came in under budget and under timeline. We were exceptionally pleased with JW and will continue to use them as we need services like theirs.
Instead of forking over $5,000-10,000 to replace all of your old windows with brand new ones, consider repairing old windows yourself. With a few hundred dollars in supplies (sand paper, paint, window glaze, etc.), you’ll be prepared to reglaze every window in your house. Though it can be a tad time consuming, you can prioritize the project by room, removing windows one by one to paint, reglaze, and, if necessary, replace any cracked glass. Get started glazing your windows here.
How to DIY it: You should already be emptying the lint trap before every load of laundry. To do a thorough cleaning of the dryer and its vent duct system, unplug the machine (and turn off the gas valve if it has one). Pry off the access panel on the front (try a putty knife covered with duct tape to prevent scratching) and vacuum around the motor and heating element (above). Then carefully disconnect the vent duct tubing from the back of the dryer and use a dryer vent brush (about $10 at home 
centers; look for one that also cleans refrigerator coils) to pull out any 
accumulated lint. Aim to do this at least once a year.
Quick-setting drywall compound lets you finish small repairs and fill deep holes in minutes instead of waiting days for premixed joint compound to dry. The small boxes are available in most home centers and paint stores are also easier to store and more likely to get used up than large bags or buckets. Click here to learn how to hang drywall like a pro. Click here to buy drywall compound on Amazon now.
Hi reader in the U.S., it seems you use Wikipedia a lot; that's great! It's a little awkward to ask, but this New Year's Eve we need your help. We depend on donations averaging about $16.36. But 98% of our readers in the U.S. are ignoring our messages, and there are only a few hours left in 2018 to help Wikipedia. If you donate just $2.75, the price of your coffee, Wikipedia could thrive. Thank you.

Hi reader in the U.S., it seems you use Wikipedia a lot; that's great! It's a little awkward to ask, but this New Year's Eve we need your help. We depend on donations averaging about $16.36. But 98% of our readers in the U.S. are ignoring our messages, and there are only a few hours left in 2018 to help Wikipedia. If you donate just $2.75, the price of your coffee, Wikipedia could thrive. Thank you.
If you’re looking for a Denver handyman who can fix a leaking faucet, replace a faulty light switch, put in a new toilet or shower, patch or replace drywall, install or build some shelving, put in a ceiling fan, paint a room, repair a fence, build a closet, or perform pretty much any other maintenance or repair project . . . Grandma’s Handyman Service in Denver can help!
Other competitors include online referral services.[10] In addition, some large home centers offer installation services for products such as cabinets and carpet installation.[16] Sometimes homeowners contact a professional service after trying, but failing, to do repair work themselves; in one instance, a Minneapolis homeowner attempted a project but called a technician to finish the project, and the overall cost was substantial.[19]
Hi reader in the U.S., it seems you use Wikipedia a lot; that's great! It's a little awkward to ask, but this New Year's Eve we need your help. We depend on donations averaging about $16.36. But 98% of our readers in the U.S. are ignoring our messages, and there are only a few hours left in 2018 to help Wikipedia. If you donate just $2.75, the price of your coffee, Wikipedia could thrive. Thank you.
Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.
×