Hi reader in the U.S., it seems you use Wikipedia a lot; that's great! It's a little awkward to ask, but this New Year's Eve we need your help. We depend on donations averaging about $16.36. But 98% of our readers in the U.S. are ignoring our messages, and there are only a few hours left in 2018 to help Wikipedia. If you donate just $2.75, the price of your coffee, Wikipedia could thrive. Thank you.
Risk: The range hood sucks cooking fumes up and out of the kitchen. As grease splatters, it builds up and clogs the filter in the underside of the hood, keeping the fan from working as it should. This could cause your smoke alarm to go off, attract fruit flies, and leave potentially harmful pollutants from your gas or electric range lingering in the air. And if you have to replace the motor, it will cost around $200.
The average single-family homeowner spends around $2,000 a year on maintenance, according to Bankrate.com. That is considerably less than the monthly fees for most condos or co-ops. But even though the monthly outlay for those homeowners might be lower than that of condo or co-op owners, house owners generally are not squirreling away those savings for a rainy day. Nearly half of them have less than $1,000 saved, and a third have nothing saved, according to Liberty Mutual Insurance. So when that sump pump suddenly fails, odds are, we’re scrambling to pay the plumber for a new one.
When you hire a contractor or specialist, they usually supply the materials, and often at a markup. If they don't provide the materials, they may not guarantee a repair, or your choices are limited to what they have in stock. When you choose your own materials, you know how much the product costs, and you can stay within your budget. You also get to choose the manufacturer, finish and register any warranty agreement.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding carpet (below).
In Need of Residential / Commercial Handyman Services? We Have the Solution For You! Our Services include the following: .•All about electricity, installations, maintenance and repairs •General building work and repairs •General handyman work and repairs •Home maintenance and repairs •Installation of bathroom accessories •Sliding glass door installation •Sliding glass door rollers replacement •Sk ...
If you have a small remodeling job or other work difficult to describe over the phone, you might be able to obtain fixed-price quotes without having to set up a bunch of appointments by emailing photos of the work area along with a detailed description of the work—the majority of the handyperson services we surveyed use email to correspond with clients.
You may qualify if all of the following apply to your household:A child under six resides in your home or spends at least six hours per week in your home on a regular basis You have owned and lived in your home for more than one yearYour home was built before 1978You live in one of these city neighborhoods:Bond Hill, Westend, Over-The-Rhine, Mt. Auburn, CUF, Corryville, Madisonville, Avondale, South Cumminsville, North and South Fairmount, West, East and Lower Price Hill, Walnut Hills, Evanston Northside or Carthage
A handyman, also known as a handyperson or handyworker, is a person skilled at a wide range of repairs, typically around the home. These tasks include trade skills, repair work, maintenance work, are both interior and exterior, and are sometimes described as "side work", "odd jobs" or "fix-up tasks". Specifically, these jobs could be light plumbing jobs such as fixing a leaky toilet or light electric jobs such as changing a light fixture.
A garbage disposal is a bit scary when it’s turned on and the blades are noisily chopping up kitchen waste. But, if your disposal gets stinky, fear not. It’s easy to clean out the gunk and get rid of the smell. If the splash guard needs replacing, you can do that in 20 minutes! If you need to replace the entire disposal you can replace it yourself.
If you can see light creeping beneath exterior doors, air is also escaping. Grab a few packages of self-adhesive rubber foam weatherstripping and go to town, sealing any and all doors that lead outside. Weatherstripping already installed but you’re still suffering from a high gas bill? It might be time to replace the strips installed by the previous owners. Check out this handy tutorial on installing weatherstripping.
While you’re at it: Any appliance that uses water has a shutoff valve. But when valves go untouched for years, mineral deposits can make them impossible to close. Before that happens, locate the valves for your washer, ice maker, water heater, etc., and turn the handle (clockwise, about a quarter turn) every year or so (more often if your water is very hard), and then turn it back. Here are some ten-minute maintenance tasks you didn’t know you needed.
When vinyl windows and doors don’t operate smoothly, it’s usually because gunk has built up in the channels. But sometimes even clean windows and doors can bind. Try spraying dry PTFE spray lubricant on the contact points and wiping it off with a rag. Don’t use oil lubricants; they can attract dirt, and some can damage the vinyl. Make sure to keep your windows clean all year long with these pro tips.
If you have shallow scratches or nicks, hide them with a stain-filled touch-up marker. Dab on the stain and wipe off the excess with a rag. But beware: Scratches can absorb lots of stain and turn darker than the surrounding finish. So start with a marker that’s lighter than your cabinet finish and then switch to a darker shade if needed. For deeper scratches, use a filler pencil, which fills and colors the scratch. Or, try using a walnut to remove scratches in wood!
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill or a screwdriver, and then reattach everything.
How to DIY it: A simple cleaning often solves the problem. Start by pulling out the lower dish rack. Remove the spray arm and use a thin piece of wire to clean out the holes where water sprays through. Scoop or vacuum out any leftover food particles from the filter area, then remove the filter screen (above), if possible, and give it a good rinse.
Two-part epoxy glue is rock-hard, fills huge gaps, bonds to almost anything and dries very quickly. Some brands now come with an applicator tip that automatically mixes the two parts so you can spread it like a regular glue, without mixing. It’s perfect for gluing irregular shapes and dissimilar materials to each other. Most epoxies set in five minutes, but you can buy quicker-setting types that allow you to just hold pieces in place for a minute, without any clamping. Pick up some epoxy glue on Amazon today.
Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.