If you find that drawer slides are bent, rollers are broken or rollers won’t turn even after lubricating, replacement is the best solution. To keep the project simple, buy new slides that are identical (or almost identical) to the old ones. That way, replacement is an easy matter of unscrewing the old and screwing on the new. Remove a drawer track and a cabinet track and take them shopping with you. Learn how to build an under-cabinet drawer here.


Risk: If your house was built 
before 1994 and still has the original plumbing fixtures, you’re using 
30 to 40 percent more water than 
a comparable new home. Because about 70 percent of the water flowing through the showerhead is hot, 
that means higher heating bills too. A basic showerhead can cost just $15 and could pay for itself in reduced water and heating costs after just one month. Calculate your 
savings at epa.gov/watersense/watersense-calculator.
The table below reports labor charges for one to six hours of work (per worker) for a sample of area handyperson services. (Rates were collected by our telephone shoppers who did not disclose their affiliation with Consumers' Checkbook.) As you can see, there are big differences: For one hour of work, you can pay between $50 and $259; for six hours between $300 and $774. The table also shows companies’ hourly rates.
PWC provides critical – not cosmetic – home repair services to its clients. This type of home maintenance is performed by PWC’s trained, licensed and bonded staff of skilled tradesmen, including plumbers, electricians, carpenters, and HVAC technicians. Depending on your location and your specific needs, below are some of the services you could receive:
If you have shallow scratches or nicks, hide them with a stain-filled touch-up marker. Dab on the stain and wipe off the excess with a rag. But beware: Scratches can absorb lots of stain and turn darker than the surrounding finish. So start with a marker that’s lighter than your cabinet finish and then switch to a darker shade if needed. For deeper scratches, use a filler pencil, which fills and colors the scratch. Or, try using a walnut to remove scratches in wood!
How to DIY it: Turn it off by opening the disconnect box (typically located on the outside wall near the unit) and pulling out the disconnect block inside (above). Now take a good look at the unit. If the vents are caked with fuzz from dandelions or cottonwood trees, vacuum the vents. Then rinse the unit with a hose using moderate pressure (the flimsy fins might bend under strong pressure). As you spray, peer down into the unit. You should see water streaming through. If not, the fins are still clogged, so keep rinsing.
If you have a small remodeling job or other work difficult to describe over the phone, you might be able to obtain fixed-price quotes without having to set up a bunch of appointments by emailing photos of the work area along with a detailed description of the work—the majority of the handyperson services we surveyed use email to correspond with clients.
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.
With Grandma’s handymen in Aurora, Parker, Highlands Ranch and Denver, handyman help is just a phone call away! Our Denver handyman staff specializes in home maintenance and repair, and is experienced in a variety of trades including plumbing, painting, drywall, electrical, and carpentry. Click here for a list of our handyman services in Aurora, Denver, Parker, Highlands Ranch, Lone Tree, Centennial, Littleton, Lakewood, and Englewood.
You’ve got an ever increasing to-do list of home improvements like changing out a bathroom faucet, replacing missing shingles on the roof and painting a kitchen wall. You could hire a plumber, roofer and painter who have conflicting schedules and their own service charges, or you could hire a handyman to complete all three projects in one day for one hourly rate.
How to DIY it: Gently tug the loose part of the carpet to find the point where it’s still attached. Snip 
it off as close to the backing as possible and save it. Use painter’s tape to surround the repair area. Squeeze 
a heavy bead of carpet seam sealer (about $6 at home centers) into the run. Then fill in the hole with the saved fiber, using a screwdriver to press it into the sealer bit by bit until the area looks like the surrounding 
carpet (below).
Any property repair services are only as good as the people and the tools behind them. That’s why we use only the latest repair and maintenance equipment on every job, no matter how small. Part of our job is to ensure your house is up-to-date and looking its best, so we use only the best resources available in order to make that happen. We offer a variety of handyman services throughout the DC area, including all of the following:

There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project.
Simple fixes for the four most common refrigerator problems: an ice-maker breakdown, water leaking onto the floor, a cooling failure and too much noise. Chances are, you can solve the problem yourself, save some money and avoid the expense and inconvenience of a service appointment. The following article will walk you through the simplest solutions to the most common fridge malfunctions. Learn how to repair a refrigerator here.
×