If you don’t cover paint chips with touch up paint, they’ll rust and then you’ll have a much bigger problem on your hands. The actual touch up is easy. Just buy touch up paint, fine tip paint applicators and wax and grease remover from any auto parts store. Clean the chip with the wax and grease remover and let it dry. Then dip the applicator in the paint and dab it onto the chip. Don’t add too much or the paint will drip. Let it dry completely and apply wax after 30 days. Get the full guide to using auto touch-up paint here.
If you’re looking for a Denver handyman who can fix a leaking faucet, replace a faulty light switch, put in a new toilet or shower, patch or replace drywall, install or build some shelving, put in a ceiling fan, paint a room, repair a fence, build a closet, or perform pretty much any other maintenance or repair project . . . Grandma’s Handyman Service in Denver can help!
When Scott began the rebuilding of my shower stall, he discovered something very unexpected! When he removed part of the floor to make the shower stall larger, he discovered water damage and black mold all over the sub-floor. Apparently our toilet had been leaking, just slightly, under the floor with every flush! We had no knowledge that this had been going on for years!
Two-part epoxy glue is rock-hard, fills huge gaps, bonds to almost anything and dries very quickly. Some brands now come with an applicator tip that automatically mixes the two parts so you can spread it like a regular glue, without mixing. It’s perfect for gluing irregular shapes and dissimilar materials to each other. Most epoxies set in five minutes, but you can buy quicker-setting types that allow you to just hold pieces in place for a minute, without any clamping. Pick up some epoxy glue on Amazon today.
Don’t fall for a shingle shakedown! Not all local handyman services have your best interests in mind.  Instead of repairing damaged roofing or siding, they recommend a full replacement, which doesn’t always make financial sense. At Brothers Services, we believe in treating people fairly and making sure you know your options, including affordable ways to extend the life of your roofing and siding.
If a screw turns but doesn’t tighten, the screw hole is stripped. Here’s a quick remedy: Remove the screw and hardware. Dip toothpicks in glue, jam as many as you can into the hole and break them off. You don’t have to wait for the glue to dry or drill new screw holes; just go ahead and reinstall the hardware by driving screws right into the toothpicks.
How to DIY it: Take off the loose bar by removing the screws on each of the posts that mount the bar to the wall. (If one side is solidly attached, leave it alone.) With the mounting plate now exposed, try tightening 
the screws in it. If that doesn’t work, remove it. Chances are you’ll find two plastic anchors underneath. Poke them with 
a screwdriver and let them fall inside the wall. Replace with bigger, stronger metal toggle 
anchors (above), sold at hardware stores. Just drive them into the existing holes with a drill 
or a screwdriver, and then re­attach everything.
Two-part epoxy glue is rock-hard, fills huge gaps, bonds to almost anything and dries very quickly. Some brands now come with an applicator tip that automatically mixes the two parts so you can spread it like a regular glue, without mixing. It’s perfect for gluing irregular shapes and dissimilar materials to each other. Most epoxies set in five minutes, but you can buy quicker-setting types that allow you to just hold pieces in place for a minute, without any clamping. Pick up some epoxy glue on Amazon today.
There’s nothing worse than starting a sink or toilet repair only to find that the shutoff valve won’t shut off. Some shutoff valves are easy to replace. For those that aren’t, turn off the main water valve, remove the packing nut, and then unscrew the stem and take it to the hardware store to find a replacement washer. Clean any grit out of the valve body and pop on the new washer. The valve will work like new.
Hello my name is Leo and about 22 years ago I entered the world of construction. Throughout the years I have learned many skills and I have used my skills to help people accomplish their projects. I am a father of 4 and family time is very important to me. My family and I started our own community garden where we teach other children how to grow their own garden.
Almost nothing is quicker, easier or refreshes a room more than a new coat of paint. Even switching up a bright white for a trendy, bright grey can change your whole perspective and give you a starting point for new colors and decoration. Gallons of paint range from $30-$50, and with primer/paint combinations, you will likely only need a gallon or less to finish an average sized room. Add another $10, and you’ll be set with rollers, paint brushes, and painter’s tape. This DIY repair could potentially save you thousands over the cost of a professional painter. Short on time? Click here to learn how to paint a room fast.
Live in a condo or co-op in the city, and your monthly maintenance fee may be large enough to make you envy the owner of a single-family home. But that regular common charge means that you get to live in ignorant bliss about what it costs to keep a property functioning. You may never know when the gutters get cleaned, who gets hired to do the work or even how much the job costs. None of the details are your problem because the work just gets done whether you’re paying attention or not. 

Upholstery shops charge almost $200 to fix tears in your seats. You can do it yourself in a few hours with a vinyl and leather repair kit (less than $20) from any auto parts store. You’ll have to practice a bit to get the right color mix and it might not be a perfect match when you’re done, but it’s a heck of a lot better than driving around with torn seats. Start by gluing reinforcing fabric onto the underside of the torn vinyl or leather. Then mix the heat-set filler to match your fabric color and apply it to the tear. Next, find a textured mat that most closely resembles the texture of your vinyl or leather and place it onto the liquid filler. Heat the patching tool with a clothes iron and press it onto the textured mat. Remove the patching tool, but leave the textured mat in place until the patch cools. Then peel it off. Get the full story on repairing leather here.
Intimidated by this seemingly daunting project? Don’t be. If you have the will and a whole day (or two) to yourself, you can refinish the hardwood floors in the major areas of your home. You don’t necessarily need to sand, but if the floor is damaged enough to warrant buffing, check out your local hardware store and rent the equipment for anywhere from 4-48 hours. Here’s how to refinish your hardwood floors.
How to DIY it: This job can be messy, so protect nearby surfaces by covering them with plastic or cardboard. Spray the springs with garage door lubricant (about 
$7 at home centers). Don’t use oil, grease, or other lubricants. They may be cheaper, or you may have them on hand already, but they won’t work as well and tend to pick up dust and grit—just what you don’t want on moving parts.
In 2009, there were national handyman service firms which handle such nationwide tasks as public relations, marketing, advertising, and signage, but sell specific territories to franchise owners. A franchise contract typically gives a franchise owner the exclusive right to take service calls within a given geographical area. The websites of these firms put possible customers in touch with local owners, which have handymen and trucks. Customers call the local numbers. Typically these firms charge around $100/hour, although fees vary by locality and time of year. In many parts of the world, there are professional handyman firms that do small home or commercial projects which claim possible advantages such as having workers who are insured and licensed. Their branch offices schedule service appointments for full-time and part-time handymen to visit and make repairs, and sometimes coordinate with sub-contractors.
Many an amateur DIY enthusiast has spotted a job that needs doing and gone out to buy the appropriate tools, only to find that they're way out of their league. Book a handyman using the Handy app or website and you can be sure that they'll arrive with everything they’ll need to get the job done. In addition to your run-of-the-mill screwdrivers and hammers, your handyman specialist will read your job description before they arrive to ensure they come prepared for anything that your specific job may require. Don't worry about whether you’ve got the right tools for the job. Book a handyman through Handy and leave it to the professionals.

There's no national standard or regulation for handymen. Licensing and regulation vary by state. New Jersey, for example, requires handymen who work for a profit to register with the state and carry insurance. California requires handymen to carry a license from the State Contractors License Board to work on any project that exceeds $500 in labor and material costs. Find out before you hire the handyman if he or she has the skills needed to complete your project. Need Handyman Repairs? Click Here
×